TYDC-240S: Automatic Label Rolling Without the Manual Hassle

Nobody likes labelling wires by hand. Slow, inconsistent, and it still has to get done every shift.

The TYDC-240S does it automatically. Feed, peel, roll — one cycle. Touchscreen setup, works with different label rolls.

New operators pick it up fast. Placement doesn't vary. Output is high.

We have seen factories where one person was doing nothing but labelling all day. The 240S removes that completely. Same person can move to something else. Label position stays the same piece after piece — no checking, no fixing.

Works on wire harnesses, cables, components — pretty much anything that needs a label stuck on consistently. Label roll changeover takes a couple minutes. No tools needed. Fits most standard roll sizes so sourcing consumables is not a problem.

If your line already runs wire cutting stripping and terminal crimping as automated steps, labelling is usually the last manual bottleneck. This removes it. That's really it. Fell free to contact us.